Get the best little brass safety pins you can: the ones without the little burrs at the point. Many quilters find they can tape the backing to a large table (or linoleum floor), then layer the batting, and then tape the top, to achieve the same tautness for both top and backing.
Why does my quilt pucker on the back?
Puckers in the quilting usually result from a basting process where either the backing wasn’t spread and secured properly or too few safety pins were used or things shifted as the quilt was positioned under the needle and quilting began.
What is quilt puckering?
Puckering, little sewn-in pleats and fabric that is pulled out of place (“drag”) are all caused by shifting of the layers while quilting. … Careful basting, supporting the weight of the quilt while sewing, and adjusting your machine can make all the difference.
How do you get rid of puckering?
Set the needle thread tension to be as light as possible while achieving a balanced stitch at the same time. This will reduce the amount of puckering while the thread is stretched and improve the sewability. Use a high-quality sewing thread with a low-friction lubricant applied to it.
How do you adjust the tension on a quilt?
Quick Tips for Stress-free Tension
- Quick Tips for Stress-free Tension.
- When in doubt, re-thread the machine–both the top thread and bobbin. …
- Change your needle often. …
- Clean out lint around the bobbin case regularly. …
- Find a favorite thread and use it consistently. …
- Only make small adjustments to the tension knob.
How do you know if a quilt is square?
So what exactly does it mean to “square up a quilt?” It means all your corners are cut square at a 90° angle, and all your edges are cut straight. This will make attaching your binding much easier, and when your quilt is laid out on a bed or folded neatly, it will look professionally made.
Should I square up my quilt before adding borders?
Once your piece is quilted, you need to make the edges even and square before adding your binding. It is easier and more accurate to trim the quilt sandwich if the three layers are sewn together at the edge. Otherwise, the bottom layer can shift and you end up with edges that are not the same.