Decorate some pretty stones for your garden or desktop with a little bit of decoupage. It’s easy to Mod Podge on rocks and the results are so pretty!
Does Modge podge work on rocks?
Finish off your rocks with a coat (or two or three) of Mod Podge Outdoor. This will help protect your beautiful painted rocks from the elements.
Is Mod Podge good for sealing painted rocks?
To avoid having your Sharpie artwork ruined, you should seal rocks painted with Sharpies with at least two coats of Mod Podge or Mod Podge Waterbase Sealer before using spray sealer.
How do you make rocks look wet?
DIY tricks include clear nail polish, toothpaste, vinegar, and car wax. Depending on where you display your stones and their material properties, you may be ok using homestyle solutions, or you might need to use a combination of products to achieve a lasting, glassy look.
What do you seal a painted rock with?
Sealing your painted rocks with resin protects the paint from the elements and stops the colours from wearing off. You can buy clear casting resin at Bunnings, Office Warehouse, Spotlight, ebay and lots of other places.
Is decoupage waterproof?
It is HIGHLY water resistant. This means that if you want a decoupage item to sit on a covered porch where it is not exposed to weather 24 hours a day, you are fine using this formula by itself.
Can I use clear nail polish to seal painted rocks?
Similar to hairspray, nail polish may react badly to the acrylic paint and might destroy your design. … It would be best to opt for a proper sealant or an acrylic gloss to seal painted rocks.
Can you use hairspray to seal painted rocks?
Paints such as acrylic, tempera, and other types of paint cannot be sealed with hairspray, which is why they are not suitable for use on rocks. Paint and hairspray react badly to each other, and some formulations of hairspray may cause your paint to melt or become gooey.
How do you transfer an image to stone?
Step 1: Step 1: Transfer Your Image to Stone
- Clean the surface of your stone (remove any dirt, oil, grime, etc.)
- Apply a layer of acrylic polyurethane (or transfer gel)
- Quickly apply your laser-printed design, FACE DOWN onto the wet surface.
- Using your hand or paper towels, work air bubbles out to the edges.